Identifi cation of controls (continued), Operating with the remote control, Loading batteries – Toshiba XDE600 User Manual

Page 10

Advertising
background image

10

Introduction

Open the cover.

Insert batteries (R03/AAA size).

Make sure to match the + and – on the batteries to
the marks inside the battery compartment.

Caution
• Never throw batteries into a fi re.

Notes
• Be sure to use R03/AAA size batteries.
• Dispose of batteries in a designated disposal area.
• Batteries should always be disposed of with the environment

in mind. Always dispose of batteries in accordance with
applicable laws and regulations.

• If the remote control does not operate correctly, or if the

operating range becomes reduced, replace both batteries
with new ones.

• When necessary to replace batteries in the remote

control, always replace both batteries with new ones.
Never mix battery types or use new and used batteries in
combination.

• Always remove batteries from remote control if they are dead

or if the remote control is not to be used for an extended
period of time. This will prevent battery acid from leaking into
the battery compartment.

• Battery shall not be exposed to excessive heat such as

sunshine, fi re or the like.

Operating with the remote control

Point the remote control at the remote
sensor and press the buttons.

Distance: About 7 m (23 feet) from the front of the

remote sensor

Angle:

About 30° in each direction of the front of the
remote sensor

* Do not expose the remote sensor of the DVD player

to a strong light source such as direct sunlight or
other illumination. If you do so, you may not be able
to operate the DVD player via the remote control.

Notes on the remote control
• Direct the remote control at the remote sensor of the DVD

player.

• When using the remote control, press the buttons at

intervals of about 1 second to ensure the correct mode of
operation.

• Do not drop or give the remote control a shock.
• Do not leave the remote control near an extremely hot or

humid place.

• Do not spill water or put anything wet on the remote

control.

• Do not open the remote control.

2

Loading batteries

1

Identifi cation of Controls (continued)

Advertising