Toshiba PORTEGE M400 - Manual (Page 90)

User’s Manual 4-22
Operating Basics
Removing a module
Remove the Ultra Slim Bay module as described below.
1. Wait for the indicator light to go out to make sure all disk activity has
stopped.
2. Turn the computer upside down.
3. Remove the screw near the icon that holds the Ultra Slim Bay in place.
4. Make sure the screw in the Ultra Slim Bay lock screw is set in the hole
to the unlock position.
5. Slide the Ultra Slim Bay latch to the unlock position.
6. Grasp the optical media drive and slide it out.
Removing the optical media drive
The TOSHIBA Mobile Extension is preinstalled to support hot swapping
under Windows. Refer to Chapter 1, Introduction for information on using
this utility to change modules while the computer’s power is on.
Wait for all disk indicators to go out before you turn over the computer.
Lay the computer down gently as shock can damage the hard disk drive or
other components.
The optical media drive and other Ultra Slim Bay modules can become hot
with use. Be careful when removing the module.
Store the DVD Super Multi drive unit in the Ultra Slim Bay Case when
removing it from the computer or transporting it.
Lock screw
Optical media drive
Ultra Slim Bay latch