Toshiba Satellite M50 (PSM53) - Manual (Page 75)

TOSHIBA M50 4-7
Operating Basics
Disconnecting the LAN cable
To disconnect the LAN cable, follow the steps below.
1. Pinch the lever on the connector in the computer's LAN jack and pull
out the connector.
2. Disconnect the cable from the LAN hub in the same manner. Check with
your LAN administrator before disconnecting from the hub.
Enable/Disable the Wake-up On LAN feature
By default, the Wake-up On LAN feature is disabled which means that it is
not possible for a network administrator to remotely start the computer when
it has been switched off in shutdown mode. If you wish to enable this feature,
please follow the steps below, although you should note that it is only
supported when the computer is connected to the AC adapter.
A. First Time Configuration
This process configures both the network adapter and the computer's
hardware setup application to enable the Wake-up On LAN feature:
1. Within Windows, click [start]->[Control Panel]->[Toshiba HWSetup] and
then select the [LAN] tab.
2. Select [Enabled] within the Wake-up on LAN section.
3. Click [Apply] and then click [Yes] to restart the system.
4. After the system has restarted click [start]->[Control Panel]->Select
[System].
5. Within the System Properties window, select the [Hardware] tab and then
click [Device Manager].
6. Within the Device Manager window, click the '+' symbol next to [Network
adapters] and then double-click [Marvell Yukon 88E8036/8053 PCI-E
Fast Ethemet Controller].
7. Select the [Advanced] tab and then choose the [Wake From Shutdown]
property.
8. Select [On] from the Value list and then click [OK] to close the dialog box.