Beko BD-300 - Manual (Page 15)

1. Disconnect the power lead from the back of the base unit
2. Press and hold the HANDSET LOCATOR button in the base unit, at the same time
connect the power lead into the back of base unit. Release the LOCATOR button
after you hear “beep” sound for five times. The IN USE light on base unit lights
during this whole process.
3. After 2~3 seconds, you can hear “beep” sound for two times again and the IN USE
light goes off;
4. Disconnect the power lead from base, and then connect it again, you will hear
confirmation tone from the base unit.
Handset registration
Your phone is supplied with the handset already registered to the base unit, and you shouldn't
need to register it. But if you've bought extra handsets separately, you'll need to register each
one to your original base unit. Maximum 4 handsets can be registered to one base.
To register a handset
5. Press and hold the Handset locator button on the base unit for a while, until you hear
"beep" sound twice continuously.
6. Press the MENU button, then press UP/DOWN button to the location REGISTER
7. Press the OK button, then press UP/DOWN button to the location SUB BASE
8. Press the OK button again
The display shows BASE? 1 2 3 4
9. Key in a base unit number
The display shows SEARCH + selected number, then shows the ID of the base unit
after 3~4 seconds.
10. Press the OK button again
The display shows PIN?
11. Key in your pin (default 0000) and press OK to confirm.
If the display says NOT REG, check to see if you key in the correct PIN, then
repeat the registration procedure again from step 1.