Beko BD-300 - Manual (Page 16)

Intercom and transfer
To make an intercom call
1. Press the INT button
2. Key in the number of the other handset
On the other handset's display, your number appears, and the INT symbol flashes. Then the
other handset user presses the CALL button to connect the call.
For details of how to change the ringing melody and volume for intercom calls, see "INT
MELODY" and "INT VOLUME" on "HANDSET SETTING" part.
To end an intercom call
Press the CALL button on your handset
The other person will hear Busy tone, and should also press the CALL button to hand up.
To transfer the outside call to another handset (if you have two or more handsets):
Press the INT button and key in the number of the other handset.
The outside call is put on hold. When the other handset answers, you can speak to the
user. If the other handset does not answer, you can get back to the outside call by
pressing the INT button again.
To transfer the outside call to another outside phone:
Press the Recall button and key in the call number you want to transfer.
The first party is put on hold. When second party answers, you can speak to the user,
then press the CALL button to hang up and transfer the call.
Note: Network Depending
Troubleshooting
Always check first that:
You have followed the steps listed on pages to install and set up your phone.
All connects are firmly inserted in their sockets.
Mains power is switched on at the socket.
The handset’s batteries are correctly and securely installed, and are not run down.
If you experience difficulties with the working of your phone, refer to the advice given below.
I cannot make or answer calls.
Check that the base unit’s mains power adapter is plugged in and power is switched on. The
base unit needs mains power for normal operation of the phone-not just charging the batteries.
Make sure you are using the telephone line cable that was supplied with your phone. Other
telephone line cables might not work.
Move the handset closer to the base unit.