Briggs & Stratton Model 040205-0 User Manual
Page 16
BRIGGSandSTRATTON.COM
14
Problem
Cause
Correction
Cannot cancel the alarm.
Dialer is not operating properly.
Replace battery in GenAlert.
External phone area problems.
Check with your phone company if you
suspect problems.
Called the wrong number.
Verify the right phone number.
I can’t change the alarm
message.
GenAlert is designed this way. No
cause.
The alarm message is pre-recorded at our
factory and cannot be changed.
GenAlert will not work on
my multi-line business
phone systems, PBX
systems or digital phone
systems?
GenAlert is designed to work only
with a single phone line, found in
most residential homes. Sharing
a phone line with a phone, fax
machine, or computer modem
is acceptable as long as they are
sharing a single phone line.
Some PBX systems simply require a “9” to
be dialed before calling the programmed
number. GenAlert should be able to dial the
“9” and the rest of the number. You may
need to enter a pause after the 9 to wait for
the dial tone before the rest of the number
is dialed by the GenAlert.