Beko D 5001 EM - Manual (Page 24)

23 GB
Delayed Start Button (8)
You can delay the start of the selected
program until 24 hours with increments
of 1 hour by means of the Delayed
Start Function.
Program Selection
You can select the desired program
after turning on the machine by
pressing the On / Off button ( 1).
Switch to the program you want to
operate by pressing program selection
button ( 3). You can follow up the
program you are in from the program
indicator ( 11) on the screen. Program
number will increase by one each time
you press the program selection button
(Number of the defined programs can
change depending on the model you
have hhhpurchased). The selected
washing program will start running
when the Start / Pause / Cancel
button ( 7) is pressed. Time indicator
( 12) will start displaying the estimated
remaining time to the end of program.
Total time can be different from
the time indicated at the beginning
since it can change while the
program is running, depending
on the temperature of the room
where your machine is installed,
temperature of the supply water,
autotcleaning of the water softening
system (regeneration) and amount
of the dishes.
Adding Functions to the
Program
With the help of the add function
buttons, you can run the selected
program together with the Half Load
(1/2) ( 4), Extra Drying (5), Combi
Tablet ( 2) and Delayed Start (8)
functions.
You will obtain a better drying
performance if you select the Combi
Tablet function in cases where you use
a multi-purpose detergent.
To add a function to the program:
1. Select the program by pressing
program selection button ( 3).
2. Press the button of the function
that you want to enable and
check to see thee indicator for the
relevant function on the display.
3. You can start the program by
pressing the Start / Pause / Cancel
button ( 7).
Program Steps Followtup
You can follow-up the step in which the
current program is in from the Program
Steps Follow-up indicator ( 19) on the
display.
a Washing Step Indicator (19 a)
b Rinsing Step Indicator (19 b)
c Drying Step Indicator (19 c)
d End of Program Indicator (19 d)
The display shows the steps for
washing 19 a, rinsing 19 b and drying
19 c, respectively, while the selected
program is running. Only the End of
Program indicator 19 d lights up when
the program is over. Remaining Time
Indicator ( 6) displays “00:00”.
Canceling a Program
Press Start / Pause / Cancel button ( 7)
for three seconds to cancel a program
that is already running. Release the
button when indicator and End of
Program Indicator ( 19 d) start flashing
above the program indicator ( 11) in the
display. For a couple of minutes the
machine will fulfill the necessary
operations required for cancellation.
End of Program Indicator ( 19 d) starts