Beko D 5001 EM - Manual (Page 27)

26 GB
Starting Your Machine
•
Plug the mains plug into the wall
socket.
•
Open the tap.
•
Open the door.
•
Place the dishes.
•
Check if the upper and lower
impellers rotate freely.
•
Put sufficient amount of detergent
in the detergent dispenser and
close its lid.
•
Press On/Off button.
•
Check if the salt and rinse aid
warning indicators (17,18) light
and add salt and/or rinse aid if
needed.
•
Determine your washing program
with the aid of the Program
Data and Table of Average
Consumption Values.
•
You can select the determined
washing program by pressing
program selection button (3).
•
You can see the program time in
the Remaining Time Indicator (6).
•
If necessary, you can change your
washing program as you prefer
by means of the Add Function
Buttons (4,5,2,8).
•
Start the program by pressing the
Start / Pause / Cancel button (7).
WARNING:
Pay attention not to open the door
of the machine when it is running.
Stop the machine by pressing Start /
Pause / Cancel button ( 7) if you have
to open the door. Then, open the door
of your machine. There may be a rush
of vapor when you open the door of
your machine; be careful. Close the
door and press Start/Pause/Cancel
button ( 7) again. Program will resume
running.
•
End of Program indicator ( 19 d)
will light up.
•
Turn off your machine by pressing
On / Off button ( 1).
•
Close the tap.
•
Unplug the mains plug from the
wall socket.
•
Leave your dishes in the machine
for about 15 minutes after they
are washed in order to have them
cooled down. Your dishes will dry
in a shorter time if you leave the
door of your machine ajar during
this period. This will increase
the drying effectiveness of your
machine.