Gb-10, Display button tips on saving energy – Sharp AY-XP9LSR - AE-X9LSR User Manual

Page 12

Advertising
background image

GB-10

NOTE ON OPERATION

Press the DISPLAY button when the lamps

on the unit are too bright. (The red OPER-

ATION lamp and the orange TIMER lamp

cannot be turned off.)

1

During operation, press the DIS-

PLAY button.

• The blue PLASMACLUSTER lamp and/or

the green FULL POWER lamp (

) will

turn off.

TO LIGHT UP
Press the DISPLAY button again.

DISPLAY BUTTON

TIPS ON SAVING ENERGY

Below are some simple ways to save en-

ergy when you use your air conditioner.
Set the proper temperature

• Setting to higher or lower then necessary tem-

perature point will result in increased power

consumption.

Block direct sunlight and prevent drafts

• Blocking direct sunlight during cooling opera-

tion will reduce power consumption.

• Close the windows and doors during cooling

and heating operations.

Keep fi lter clean to ensure the most ef-

fi cient operation
Turn off the circuit breaker when the

unit is not used for an extended period

of time

• The indoor unit still consumes a small amount

of power when it is not operating.

1

OPERATING CONDITION

INDOOR TEMP. OUTDOOR TEMP.

COOLING

Upper limit

32 ˚C

46 ˚C

Lower limit

21 ˚C

21 ˚C

HEATING

Upper limit

27 ˚C

24 ˚C

Lower limit

–7 ˚C

• The built-in protective device may prevent the

unit from operating when used at higher tem-

perature than this range.

• Condensation may form on the air outlet if the

unit operates continuously in the COOL or

DRY mode when humidity is over 80 %.

WHEN POWER FAILURE OCCURS

• This air conditioner has a memory function to

store settings when a power failure occurs.

After power recovery, the unit will automati-

cally re-start in the same settings which were

active before the power failure, except for

timer settings.

• If a power failure occurs while the timer is set,

the timer setting will be cancelled and will not

be retrieved even after the power is restored.

NOTE ON HEATING OPERATION

DEFROSTING FUNCTION

• When frost forms on the outdoor unit during

heating operation, the unit operate automatic

defrosting for about 5 to 10 minutes to remove

the frost. During defrosting, the inside and out-

side fans stop operating.

HEATING EFFICIENCY

• The unit employs a heat pump that draws

heat from the outside air and releases it into

the room. The outside temperature therefore

greatly affects the heating effi ciency.

• If the heating efficiency is reduced due to

low outside temperatures, use an additional

heater.

• It takes time to warm up and heat the entire

room because of the forced air circulation sys-

tem.

Advertising
This manual is related to the following products: