Sharp AY-XP9LSR - AE-X9LSR - Manual (Page 6)

GB-4
LOADING BATTERIES
1 Remove the battery cover.
2 Insert two batteries. (AAA(R03))
Make sure the (+) and (-) polarities are cor-
rectly aligned.
3 Reinstall the battery cover.
4 Press the RESET button using a
thin stick.
NOTE:
• The battery life is approximately 1 year in nor-
mal use.
• When replacing the batteries, always change
both and use the same type.
• If you will not be using the unit for a long time,
remove the batteries from the remote control.
USING THE REMOTE CONTROL
Battery cover
HOW TO USE THE REMOTE CONTROL
Point the remote control towards the re-
ceiver window and press the desired but-
ton. The unit generates a beep when it
receives the signal.
• Make sure nothing, such as curtains, block the
signal receiver window.
• The signal effective distance is 7 m.
CAUTION:
• Do not expose the receiver window to direct
sunlight. This may adversely affect its opera-
tion.
• Use of certain fl uorescent lamp in the same
room may interfere with transmission of the
signal.
• Do not leave the remote control in direct sun-
light or near a heater. Protect the remote con-
trol from moisture and shock.
7 m
Receiver window
RESET button
Use this mode when the remote control is
not available.
TO TURN ON
Press the AUX button.
• The red OPERATION lamp ( ) will light
and the unit will start operating in the AUTO
mode.
• The fan speed and temperature setting are
set to AUTO.
TO TURN OFF
Press the AUX button again.
• The red OPERATION lamp ( ) will turn off.
AUX
AUXILIARY MODE