Sharp AY-XP9RMR-AE-X9RMR - Manual (Page 14)

GB-12
MAINTENANCE
Be sure to stop the operation and turn off the
circuit breaker before performing any mainte-
nance.
CLEANING THE FILTERS
1. Remove the filters.
1. Lift the open panel.
2. Pull the air filters down to remove them.
2. Clean the filters.
Use a vacuum cleaner to remove dust. If the
filters are dirty, wash them with warm water
and a mild detergent. Dry filters in the shade
before reinstalling.
3. Reinstall the filters and close the open
panel.
CLEANING THE UNIT AND THE
REMOTE CONTROL
• Wipe them with a soft cloth.
• Do not directly splash or pour water on them. It
can cause electrical shock or equipment dam-
age.
• Do not use hot water, thinner, abrasive powders
or strong solvents.
MAINTENANCE AFTER AIR
CONDITIONER SEASON
1. Operate the unit in the FAN mode for about half a
day to allow the mechanism to thoroughly dry.
2. Stop the operation and turn off the circuit
breaker.
3. Clean the filters, then reinstall them.
MAINTENANCE BEFORE AIR
CONDITIONER SEASON
1. Make sure that the air filters are not dirty.
2. Make sure that nothing obstructs the air inlet or
outlet.
TIPS ON SAVING ENERGY
Below are some simple ways to save energy
when you use your air conditioner.
Set the proper temperature
• Setting too higher or lower than necessary
temperature point will result in increased power
consumption.
Block direct sunlight and prevent drafts
• Blocking direct sunlight during cooling operation
will reduce power consumption.
• Close the windows and doors during cooling and
heating operations.
Keep filter clean to ensure the most efficient
operation
Turn off the circuit breaker when the unit is
not used for an extended period of time
• The indoor unit still consumes a small amount of
power when it is not operating.
01_AYXP9_12RMR_OM_EN.indd 12 14/08/29 16:48