Sharp MX-7040N - Manual (Page 13)

13
Job Build
Tap this to switch the job build mode on or off.
Setting it to On scans a large number of originals in segments.
Slow Scan Mode
Tap this to switch the slow scan mode on or off.
Setting it to On prevents slips or other thin paper sheets from
getting jammed when they are scanned.
Mixed Size Orig.
Use this to switch the mixed size original mode on or off.
Setting it to On scans originals of different sizes together using the
automatic document feeder.
Original Count
Tap this to switch the original count setting on or off.
Setting it to On sends fax after checking the scanned number of
original sheets.
Select among addresses
recently sent to
Select a destination from the transmission log screen.
Call Search Number
Select a destination from the search number.
Send Directly
Sends the scanned original without saving it to the memory.
Global Address Search
A destination is searched for in the global address book.
Viewing original settings
Displays the original settings on the lower centre of the panel.
Others
Specify the edge erase (centre erase) and
erase width of the original to be sent
Scans each facing page of a bound document Sends a pamphlet original by splitting it by page
Sends both sides of a card as a single page
Automatically performs transmission or polling
reception at the specified time
Stamps scanned originals (optional)
Select sender information for fax transmission Prints the transaction report
Use this to register and manage the data to be
sent when receiving data from the other machine
by polling, as well as manage the data received by
confidential reception.
Saves the send data on the hard disk drive of
the machine.
Temporarily saves the send data on the hard disk
drive of the machine
Sends two pages as a single page
The original data placed in the other machine is
retrieved by operating your machine
FAX
This manual contains references to the fax function. However, please note that the fax function is not available in some countries and regions.