Sharp MX-7040N - Manual (Page 6)

6
CAUTIONS
Do not insert or remove the power plug with wet hands.
This may cause electrical shock.
When removing the power plug from the outlet, do not pull on the cord.
Pulling on the cord may cause damage such as wire exposure and breakage,
and may result in fire or electrical shock.
If you will not use the machine for a long time, be sure to remove the power plug from the outlet for
safety.
Be sure to connect the power cord only to a power outlet that meets the specified voltage and current
requirements.
Also make certain the outlet is properly grounded. Do not use an extension cord or adapter to connect other devices to
the power outlet used by the machine. Using an improper power supply may cause fire or electrical shock.
* For the power supply requirements, see the name plate in the lower left corner of the left side of the machine.
Power notes
Installation notes
Do not install the machine in a location with poor air circulation.
A small amount of ozone is created inside the machine during printing. The amount of ozone created is not
sufficient to be harmful; however, an unpleasant odor may be noticed during large copy runs, and thus the
machine should be installed in a room with a ventilation fan or windows that provide sufficient air circulation. (The
odor may occasionally cause headaches.)
Locations exposed to direct sunlight
Plastic parts may become deformed and dirty output may result.
Locations with ammonia gas
Installing the machine next to a diazo copy machine may cause dirty output.
Locations subject to vibration.
Vibration may cause failure.
Do not install the machine on an unstable or slanted surface. Install the machine on a surface that can
withstand the weight of the machine.
Risk of injury due to the machine falling or toppling.
Be sure to connect the power cord only to a power outlet that meets the specified voltage and current
requirements. Also make certain the outlet is properly grounded. Do not use an extension cord or adapter
to connect other devices to the power outlet used by the machine. Using an improper power supply may
cause fire or electrical shock.
* For the power supply requirements, see the name plate in the lower left corner of the left side of the machine.
Near a wall
Be sure to leave the clearances shown right between the unit and the nearest
wall or other surface.
For easy maintenance, you should also leave the clearances shown right around
the unit.
Locations that are excessively hot, cold, humid, or dry (near heaters, humidifiers, air conditioners, etc.)
The paper will become damp and condensation may form inside the machine, causing misfeeds and dirty output.
30cm
30cm 45cm
CAUTION
The machine includes a built-in hard drive. Do not subject the machine to shock or vibration. In particular,
never move the machine while the power is on.
• The machine should be installed near an accessible power outlet for easy connection.
• Connect the machine to a power outlet which is not used for other electric appliances. If a lighting
fixture is connected to the same outlet, the light may flicker.
WARNING
WARNING
Do not throw a toner cartridge into a fire.
Toner may fly and cause burns.
About consumables
Store a toner cartridge out of the reach of children.
WARNING