Bosch MUM 4405 UC - Manual (Page 12)

12
Use of mixing bowl with beating whisk or
stirring whisk
Before beginning to attach this or any other
attachment, make sure that the power unit
is on a smooth, clean, suitable surface and
switched to off position, “O/Off.”
1. Before using the mixing bowl and
beating whisk or stirring whisk for the
first time, it is recommended that the
bowl, anti-splash cover and whisk be
washed. All components are
dishwasher safe. Or they may be
washed in warm soapy water. After
washing, rinse well and dry before
using.
2. Both the stirring whisk, or beating
whisk is used in mode 1, see table 1
and figure 4. Follow the same step as
shown in figure 4, but for 4d insert the
whisk you wish to use rather than the
dough hook and its deflector.
3. Once the whisk is in place, check to
make sure it is fully inserted and then
rotate the arm to the down position by
pressing the release button and
lowering the arm.
Note: If the drives had not been parked after
last use, it may be necessary to plug
in the power cord and turn the rotary
knob to the park position “P” to
position the drive to allow the whisk
to be lowered into the bowl.
Place the anti-splash cover on the
bowl. The cover has an integral filling
funnel. The cover may be removed to
add ingredients, but the cover should
be in place whenever the power unit is
in operation.The anti-splash cover
serves to prevent the escape of flour
dust at the beginning of the stirring
process and also serves to prevent
accidental contact with the moving
whisk.
Placing into Operation w/Beating
Whisk or Stirring Whisk
Make sure that the power unit is on a
smooth, clean, suitable work surface and
switched to the Off position, “O/Off.” Pull
the electrical cord or unwind the electrical
cord to the necessary length and plug into
the wall outlet. The bowl with whisk is now
ready for operation. Sample recipes may
be found in the recipe section, at the back
of this manual.
Mixing bowl tips:
1. When using the mixing bowl to knead
or mix a recipe designed to be
prepared by hand, you will find that with
the Bosch Kitchen Machine you can
usually place all the ingredients in the
mixing bowl at once. When doing this,
always place the liquids in first. This
will assure more thorough mixing.
2. When adding ingredients to a mixture:
a. Turn the rotary switch to a lower
speed
b. Add the ingredients through the
funnel
Removing Contents
Before beginning to remove the contents
from the mixing bowl, make sure that the
power unit has been turned to the park
position “P,” to position the drive, and then
to the off position, “O/Off.” Remove the anti-
splash cover. Once the cover has been
removed, the release button may be
depressed and the ergonomic arm, lifted
upward, see figures 4a and 4b. The dough
hook or the whisk may be removed by
pulling outward with a straight, steady
motion.
The mixing bowl can be removed from the
power unit by lifting.
The contents may now be used as desired.