Bosch MUM 4405 UC - Manual (Page 9)

9
5. Operate unit with rotary switch.
Once the attachment is in place, the
speed of its moving components can
be controlled through the use of the
rotary switch at the side of the
ergonomic multifunction arm. See
figure 2a. The rotary switch has six
positions:
a. “P,” a park position used to “park”
the drive unit prior to changing the
positions of the ergonomic multi-
function arm.
b. “O/Off,” the off position.
c. Four speeds labeled 1, 2, 3 and 4.
Speed 1 is the lowest speed. The
speed increases with each
succeeding step up to the highest
speed, speed 4.
All models of the Bosch Compact
Series Kitchen Machines incorporate
an electronic safety control to protect
the motor. If the safety becomes
activated, the motor will stop running.
Turn the machine to off and allow to
cool. See TROUBLESHOOTING at the
back of this manual.
WARNING
Operate the appliance with the attachments
in their operating positions, as shown in
table 1, only. Do not operate at no load.
6. Turn power unit off.
When your work with the attachment
is completed or the capacity of the
batch feed attachment has been
reached, turn the power unit to off
position, “O/Off,” turn the rotary knob
to the “P,” park position, to place the
drives to their parked positions, and
then unplug.
7. Remove the attachment.
Remove the attachment from the
power unit, in some cases it will be
necessary to move the arm to allow
removal of the attachment. Refer to the
instructions for the specific
attachment being used.
8. Continue use.
If the attachment was of the batch feed
type and you wish to continue using
the attachment, empty the bowl or jar
of the attachment per its specific
instructions and reinstall the
attachment as before. Repeat the
steps 5 through 7 as often as
necessary to complete necessary
work.
9. Work completed,
remove attachment.
If the attachment is of the continuous
feed type, or is the batch type, and
you have completed the work you
wished to perform with the
attachment, remove the attachment
from the power unit. In some cases it
will be necessary to move the arm to
allow removal of the attachment. Refer
to the instructions for the specific
attachment being used.
10. Place contents (batch feed type).
If the attachment is the batch feed
type, disassemble per the specific
attachment’s instructions and place
the contents in a suitable container.
11. Care and Cleaning.
Once you have completed working
with the Bosch Kitchen Machine, the
next step is to disassemble and clean
the attachments. If you wish to use
another attachment, please return to
step 4, above.
Power unit
With the power unit turned off and
unplugged, it should be cleaned only with
a clean, damp cloth. Then wipe off the motor