Britax Car Sea - Manual (Page 8)

13 12
Installation Installation
Lap-Shoulder Belt Installation
Figure A illustrates a typical lap-
shoulder vehicle belt configuration.
1 Insert recline bar into holes on
rear of restraint (see page 18).
2 Place the child restraint in a
forward facing position on the
vehicle seat.
3 Pull the vehicle belt out and pass it
through the first belt slot, from the
front of the restraint to the rear (Fig B).
4 Route the vehicle belt around
the back of the restraint then
through the second belt slot,
from the rear of the restraint to
the front (Fig. C).
B
A
C D
5 Verify that the vehicle belt is
not twisted, then buckle. (Fig. D).
6 Push restraint into the vehicle
seat with your full weight while
removing all slack from the vehicle
belt. First remove slack from the
lap portion of the vehicle belt, then
the shoulder portion (Fig. E & F).
7 Verify that the vehicle belt is
tight and the child restraint is
secure.
Refer to Figure G for correct
routing of the lap-shoulder vehicle
belt.
Installation can be improved by the
use of the Versa-Tether
™ (see
pages 16–17 ).
IMPORTANT: Always use the
Versa-Tether for children
weighing more than 50 pounds
(22.6 kg).
Removal
To remove the child restraint,
unfasten the vehicle belt and
reverse the above directions.
E
F
G
P2219_R02f.qxd 11/7/2002 10:23 AM Page 14