Britax Car Sea - Manual (Page 9)

15 14
Installation Installation
Lap Belt Installation
Figure A illustrates a typical lap belt
configuration.
1 Insert recline bar into holes on
rear of restraint (See page 18).
2 Place the child restraint in a
forward facing position on the
vehicle seat.
3 Pull the vehicle belt out, then pass
the vehicle belt through the first belt
slot, from the front of the restraint to
the rear (Fig. B).
4 Route the vehicle belt around
the back of the restraint then
through the second belt slot,
from the rear of the restraint to
the front (Fig. C).
B
A
C
5 Verify that the vehicle belt is
not twisted, then buckle. (Fig. D).
6 Push restraint into the vehicle
seat with your full weight while
removing all slack from the vehicle
belt (Fig. E).
7 Verify that the vehicle belt is
tight and the child restraint is
secure.
Installation can be improved by the
use of the Versa-Tether
™ (see
pages 16–17 ).
IMPORTANT: Always use the
Versa-Tether for children
weighing more than 50 pounds
(22.6 kg).
Removal
To remove the child restraint,
unfasten the vehicle belt and
reverse the above directions.
D
E
P2219_R02f.qxd 11/7/2002 10:23 AM Page 16