Neff C77V60N2 - Manual (Page 50)

Neff C77V60N2 | 02/2012
48 | English
The filter is no longer effective when the
Service - change filter display appears, or
at the latest after two months.
It needs to be replaced for reasons of
hygiene and so that there is no build-up
of limescale (this could damage the appli-
ance). Replacement filters can be obtained
from retailers or customer service (see
“Accessories”).
After every filter change the filter must first
be rinsed. Proceed as described at the be-
ginning of this section.
If no new filter is used, turn the water filter
setting to Off .
You can find detailed information
about the water filter in the en-
closed filter instructions.
If the appliance has not been used
for a prolonged period (e.g. during
your vacation) the filter should be
rinsed before the appliance is used
again. To do this, simply dispense a
cup of hot water.
Further entries in the Settings menu:
Descale : If you want to descale the appli-
ance, press
z
(6) and run the descaling
programme (see “Descaling”).
Clean : If you want to clean the appliance,
press
z
(6) and run the cleaning
programme (see “Cleaning”).
Calc‘n‘Clean : If you want to de scale and
clean the appliance at the same time, press
z
(6) and run the Calc‘n‘Clean pro-
gramme (see “Calc‘n‘Clean“).
Factory settings : You can cancel your own
settings and reset to the factory settings. To
activate the factory settings, press
z
(6).
The appliance can also be reset to
the factory settings as follows:
1. Switch the appliance off fully at the
power switch O/I (7).
2. Press
Y
(2) and
Z
(5) at the same time,
hold them down, and switch the appliance
on again at the power switch O/I (7).
The factory settings are reactivated.
Set per-cup quantity
The per-cup quantity can be adjusted
individually to suit your cups. It can be set
separately for each type of drink and each
cup size.
1. To call up the default settings, keep i (1)
depressed for at least 3 seconds.
2. Select Cup volume with the retractable
navigation button (4).
3. Press
Z
(5).
4. Select the type of beverage with the re-
tractable navigation button (4).
5. Press
Z
(5).
6. Select the cup size with the retractable
navigation button (4).
7. Press
Z
(5).
8. Adjust the beverage quantity with the
retractable navigation button (4).
Y
(2) returns you to cup size and drink
selection. To quit the default settings, press
i (1). The settings are stored.
Important: The selected amount
in ml is an approximate value and
can vary significantly as a result of
crema forming, the grind setting or
the type of milk used, etc.