Neff S66M63N1GB - Manual (Page 23)

Fault, what to do? en
23
4. Clean spray arms under running
water.
5. Re-engage or screw on spray arms.
3
Fault, what to do?
Fault, what to do?
Experience has shown that you can
rectify most faults which occur in daily
operation yourself. This ensures that
the machine is quickly available to you
again. In the following overview you can
find possible causes of malfunctions
and helpful information for rectifying
them.
Note
If the appliance stops during
dishwashing or does not start for no
obvious reason, first run the Abort
programme function (Reset).
(See chapter entitled “Operating
the appliance”)
m
Warning – Don’t forget: Repairs may
be carried out by technicians only. If a
component has to be replaced, ensure
that only original spare parts are used.
Improper repairs or use of non-original
spare parts may cause considerable
damage and put the user at
considerable risk.
Waste water pump
Large food remnants in the rinsing water
not retained by the filters may block the
waste water pump. The rinsing water is
then not pumped out and covers the
filter.
In this case:
1. First disconnect the appliance from
the power supply.
2. Remove the filters 1:.
3. Scoop out water, use a sponge if
required.
4. Loosen screws on the pump cover
(Torx T 20) and pull off.
5. Check inner compartment and
remove any foreign objects.
6. Place pump cover in the original
position, press down and screw tight.
7. Install filters.