Neff S66M63N1GB - Manual (Page 35)

Installation and connection en
35
Use only a residual current operated
circuit-breaker which features
the symbol ‚. Only this extension
guarantees compliance with
the currently valid regulations.
The appliance features a water
damage protection system. Please
note the system will not function
unless the power supply
is connected.
Removing the appliance
Also observe the sequence of
worksteps here.
1. Disconnect the appliance from the
power supply.
2. Turn off the water supply.
3. Disconnect the waste water and
fresh water connections.
4. Pull out the appliance, carefully
pulling the hose behind.
Transportation
Empty the dishwasher and secure loose
parts.
Drain the appliance according to the
following steps:
1. Turn on the tap.
2. Close the door.
3. Switch on ON/OFF switch (.
4. Select programme with the highest
temperature.
The expected programme duration is
indicated on the numerical display
)".
5. Press START button `.
Programme sequence starts.
6. After approx. 4 minutes press the
START button ` until ‹:‹‚ is
indicated on the digital display.
After approx. 1 min
‹:‹‹ is indicated
on the digital display .
7. Switch off ON/OFF switch (.
8. Turn off the tap, disconnect supply
hose and drain water.
Transport appliance upright only.
(This prevents residual water from
running into the machine control and
damaging the programme sequence.)
Protection against frost
Protection against frost (Emptying the appliance)
If the appliance is in a room where there
is a risk of frost (e.g. holiday home),
empty the appliance completely (see
Transportation).
6XEMHFW WR FKDQJHV