Restarting, Changing cycles and options, Status lights – Whirlpool WFC7500VW User Manual

Page 14: Cycles

Advertising

Restarting

To restart the washer at any time, select CANCEL/DRAIN.

Changing Cycles and Options

Not all Options are available with all Cycles.

Cycles and Options can be changed anytime before START is
selected.

To stop a cycle and select a new cycle

1. Press and hold CANCEL/DRAIN for 3 seconds.

2. Select desired cycle.

3. Select the desired OPTIONS.

4. Select and hold START (for approximately 3 seconds) to

restart the washer at the beginning of the new cycle.

To cancel a cycle and to drain the washer manually

1. Press and hold CANCEL/DRAIN for 3 seconds.

2. The pump will turn on to drain out the water and the door will

unlock.

NOTE: It will take approximately 1 minute for the door to
unlock.

3. The washer cycle stops, the door unlocks and clothes can be

removed.

4. To power down the washer manually after the wash cycle is

complete, switch knob to Off position.

NOTE: If the water level is too high, the washer will drain
automatically before the door unlocks.

Status Lights

These lights show which portion of the cycle the washer is
operating.

Sensing

The washer automatically weighs items then adjusts the
Estimated Time Remaining, based on the cycle selected.

Cycle Complete

The Cycle Complete status light stays on for 1 hour after the
cycle is complete. To power down the washer manually after the
wash cycle is complete, switch knob to Off position.

Estimated Time Remaining

The cycle times vary automatically based on your water pressure,
water temperature, detergent, and clothes load. The cycle time
will be extended if oversudsing occurs or the load is unbalanced.
The oversuds routine removes extra suds and assures proper
rinsing of your garments. The options you select will also affect
the cycle times that are shown in the Preset Cycle Settings table.
The Estimated Time Remaining can change to much longer times
under extreme conditions.

Door Locked

When the Door Locked LED light illuminates, the door is locked.
The door is locked and unlocked automatically, depending on the
stage of the wash cycle. Press and hold CANCEL/DRAIN for
3 seconds to unlock the door manually. It will take approximately
1 minute for the door to unlock.

Cycles

Wash Cycles

Choose Wash Cycles by rotating the Cycle selector knob to the
desired cycle. The indicator light for the cycle selected will
illuminate. Each cycle is designed for different types of fabric and
soil levels.

■

Each cycle has a default cycle time, WASH TEMP, and may
have preset Options. The preset settings provide the
recommended fabric care for the selected cycle.

■

The preset settings can be changed anytime before START is
selected. Not all Options and Modifiers (WASH TEMP, spin
options) are available with all Cycles. Select and hold START
(for approximately 3 seconds) to continue the cycle.

Preset Cycle Settings

Each cycle has a preset Cycle Time and WASH/RINSE TEMP.
The preset settings provide the recommended fabric care for the
selected cycle. See chart.

*The cycle times vary automatically based on your water

pressure, water temperature, detergent, and clothes load. The
cycle time will be extended if oversudsing occurs or the load is
unbalanced.

Cycle

Estimated
Time*

(hr:min)

Wash Temp

Spin Speed

Normal