Blanco BFWM7 User Manual
Page 21
Attention! The filter and hose plug must be replaced
correctly. Ensure there is no lint around the seal of the
filter which could cause leaking.
18
Cleaning the pump filter
11
Attention! Hot water danger! It is possible that app.
15 lt, 90˚C hot water is inside. Be careful while taking
out the filter!
Remove the electrical power plug. Open the open the Kick plate
cover located at the bottom right side of the machine
by pushing on the marked area shown beside.
Before taking out the filter, drain the water by means of pump drain
hose. Take out the pump drain hose from its place. Place a shallow
container under the pump hose to catch the water. Remove the drain
pump hose plug and drain the water.
When all water is discharged, insert the plug into the pump hose
again and replace the pump drain hose in its place.
Open the filter while turning it counterclockwise, drain the left water
(max 30 ml) on to the filter cover. If there are any residual parts inside
the filter, take them out and clean the filter before replacing it. Then,
place the filter while turning it clockwise and at the end, close the
filter cover by pushing on the marked area again.