Brother DCP 1000 - Manual (Page 100)

13 - 2 T R O U B L E S H O O T I N G A N D R O U T I N E M A I N T E N A N C E
YL4DCP-1000-FM5.5
ERROR MESSAGE CAUSE ACTION
COOLING DOWN
WAIT FOR A
WHILE The temperature of the
drum unit or toner cartridge
is too hot.
The machine will pause its
current print job and go into
cooling down mode.
During the cooling down
mode, you will hear the
cooling fan running while
the LCD shows
COOLING DOWN and
WAIT FOR A WHILE .
You must wait and allow
the DCP to resume
printing when it is ready.
COVER OPEN
PLS CLOSE
COVER The scanner cover was
not completely closed. Open, then close the
cover.
CHECK ORIGINAL Originals were not
inserted or fed properly or
original was too long. Do not pull out the
jammed original until
you see page 13-4.
DOC. COVER
OPEN The document cover is
open. Remove any paper from
the ADF and close the
document cover.
MACHINE ERROR
XX The DCP has a
mechanical problem. Turn off the power. Then
call Brother Customer
Service:
In USA:
1-800-284-4329
In Canada:
1-800-853-6660
In Montreal:
1-514-685-6464
OUT OF MEMORY
(May occur when the
DCP is used as a
printer.)
DCP memory capacity
has been exceeded. Turn off the power, and
then turn it back on. Data
remaining in the memory of
the DCP will be deleted.
• If you have installed the
Windows ® driver, try
again after setting the
True Type mode to
“Print as Graphics” in
the PRINT menu of
your application
software.
• Reduce the print
resolution or reduce the
complexity of your
document.