Billion Electric Company BiPAC 7402VL - Manual (Page 114)

VoIP/(802.11g) ADSL2+ Router
Chapter 4: Configuration
Ethernet P1 / P2 / P3 / P4
Ethernet1 P2 / P3 / P4
Ethernet2 P3 / P4
Ethernet3 P4
Step 2: Create WAN Interface
Go to Configuration WAN ISP
wanlink
is the factory default WAN interface which in service for data/internet access. If your ISP
uses this access protocol, click Edit to input other parameters if needed. If your ISP does not use
PPPoE, you can change the default WAN connection entry by clicking Change.
From the example, 0/40 is used for data/internet and assumes PPPoE is used; click the Edit to
change the VPI/VCI to 0/40.
Click Create to setup up additional WAN interface for video applications. Total of 8 VLAN is
support; therefore, only 8 WAN interfaces can be created in the table.
From the example, PVC 0/33 to 0/39 is assigned for video using 1483 Bridged mode. Check RFC
1483 Bridged
and click Next to continue the setup.
Spaces next to VPI and VCI, type 0 and 33 in respectively. Select appropriate ATM Class,
Encapsulation Method, Acceptable Frame Type, Filter Type and PVID for Untagged Frames.
113