BeefEater Gas Barbecues - Manual (Page 5)

Australia’s Leading Barbecue
BeefEater Barbecues
5
For Your Safety
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flame.
3. Open lid.
4. If odour continues, immediately call your gas supplier or
your fire department.
For Your Safety
1. Do not store or use gasoline or other flammable vapours
or liquids in the vicinity of this or any other appliance.
2. An LPG cylinder not connected for use shall not be
stored in the vicinity of this or any other appliance.
Note:
Always use the correct size spanner (wrench) to tighten
gas fittings. Ensure that all gas fittings are spanner
tightened and then leak tested before continuing with
operation of the appliance.
Important:
Always check the gas label on the appliance to
ensure that you have the correct gas configuration
Gas Cylinder Information
10mm
Tools Required
You will need the following tools to assemble
your barbecue.
Phillips Head Screwdriver
10mm Spanner (wrench) All body nuts
19mm
19mm Spanner (wrench) for Gas Inlet Connection
Fig 4
Important
• The cylinder supply system must be arranged for vapour withdrawal. This normally means the cylinder must be upright.
• Do not store a spare LP-gas cylinder under or near this appliance.
• Never fill the cylinder beyond 80% full.
If these directions are not followed exactly, a fire causing death or serious injury may occur.
Fig 5