BeefEater Gas Barbecues - Manual (Page 7)

Australia’s Leading Barbecue
BeefEater Barbecues
7
Assembly Instructions
Fitting The Heat Reflectors
Completely remove all of the plastic film from the reflectors.
The tabbed ends of the heat reflectors face forward to the
front of the barbecue frame. The tabs fit into the slots in
the front end of the barbecue (behind the control fascia).
Key the tabs of the Vaporizers into the lower slots (between
the burners). Key the tabs of each reflector into the slots. If
slots are partially covered with enamel, work the tabs until
the enamel clears. See Fig 8.
Fitting The Burners
Remove the retaining clips from the burners, then fit the
burners - open end first, over the brass stem of the control
valves at the front of the barbecue, allowing the rear
burner lug to locate into the cross-lighting channel and
corresponding hole in the support panel at the rear or the
barbecue. To secure burners fit retaining clips (“R” shape)
into burner lugs. See Fig 9 & 10.
Fitting The Vaporizers
Remove the protective plastic film from each Vaporizer and
then fit the Vaporizers to the barbecue. The tabbed ends
of the Vaporizers face forward to the front of the barbecue
frame. The tabs fit into the slots in the front end of the
barbecue (behind the control fascia). Key the tabs of the
Vaporizers into the upper slots. The Vaporizers should be
fitted to the same side of the barbecue to which the grill is
to be placed. (They will not work if fitted under the plate). If
slots are partially covered with enamel, work the tabs until
the enamel clears. See Fig 11 & 12.
Fig 8
Fig 9 Fig 11
Fig 10