BenQ Joybook 5000 - Manual (Page 35)

Recovery CD Instructions 33
Recovery CD Instructions
You should receive a Recovery CD pack containing CDs that you can use to rebuild your system. These Recovery CDs will help you to restore the hard
disk with the original content that was installed when you purchased your Joybook 5000. Follow the steps below to rebuild your hard disk.
Note: Before you use the recovery CDs:
1. You should try to use Microsoft Windows XP System Restore tool to
restore your system under Windows. If you don't know where the
System Restore tool is, you can just insert the Recovery CD Disc 1
into CD-ROM drive under Windows, then Recovery CD will auto-
launch the Windows XP System Restore tool.
2. If you decide to use this option, it is important to back up all data
files. The Primary Partition (Drive C:) will be reformatted. The data
files on Extended Partition (Drive D:) will not be erased.
Restoring steps
1. When Joybook starts up, press Esc key to enter the Boot Menu dur-
ing Power-On Self-Test (POST) while the BenQ Joybook logo is
being displayed.
2. Insert the Recovery CD Disc 1 into the CD-ROM drive.
3. Select CD-ROM Drive from Boot Menu and press Enter key.
4. Then system will boot from CD-ROM and you will see the Quick
Restore screen.
5. When you finish the recovery process, remember to remove the
Recovery CD.
Reinstalling software or driver
To install/reinstall the software or driver that was installed when you
purchased your Joybook 5000, you could find the source files on the
Recovery CD Disc 3.