Belshaw Brothers BXC Smartbake - Manual (Page 11)

Belshaw Bros., Inc.
š 1750 22 nd
Ave. S.
š Seattle, WA 98144 š Phone 206-322-5474 š Fax 206-322-
5425
BXC Smartbake Oven MN-1881EN 5
Operation 2
Operating conditions
For the most efficient operation, the following
instructions must be followed. Failure to comply
with these guidelines may affect the warranty.
š The ambient temperature around the oven
must not exceed 115
“ F (40“ C).
š The ventilation around the oven should be
enough to ensure that there is no
condensation on or around the oven from
steam.
š It is the customer’s responsibility to arrange
for adequate ventilation and operational
clearance at the back and sides of the oven to
allow circulation of air.
Running Pre-set programs
1. Connect water ensuring there are no leaks.
2. Connect the power to a suitable outlet.
3. Turn on the oven by pressing the green
button and the following screen will appear
(Figure 2-1):
Figure 2-1
4. Press Button 4 (which corresponds to the
“select product” option in Figure 2-1) and the
program list will appear (Figure 2-2). If the
oven has not been programmed, see the
section on programming on page 3.
Figure 2-2
5. Highlight the desired program by pressing
buttons 2, 3, 5, or 6 to scroll down, up, 10
down, or 10 up, respectively.
6. Start heating the oven by pressing button 4
for a ½ load bake or button 1 for a full load
bake. The following screen will appear
(Figure 2-3). To stop heating, press the
stop/Back button at any time.
Figure 2-3