Beltronics STi DRIVER - Manual (Page 4)

Radar Antenna and Laser Lens
The rear panel of your STi should have a
clear view of the road ahead. For best
performance, do not mount the STi
directly behind windshield wipers
or tinted areas. Page 6
Alphanumeric Display
The STi’s display will show Highway,
AutoScan, or City as its power-on indication.
If you prefer, you can choose other power-
on indications. Pages 12-14
During an alert, the display will indicate
radar band, and a precise bar graph of signal
strength. Page 10
Note: In the Dark Mode the display will
not light during an alert. Page 9
Quick Reference Guide
To begin using your STi,
just follow these simple steps
1 Plug the small end of the power cord
into the side jack of the detector, and
plug the large end of the power cord
into your vehicle’s lighter socket.
2 Mount your STi on the windshield
using the supplied windshield mount.
3 Press the PWR button, located on the
left side of the front panel, to turn the
STi on.
4 Press and hold the VOLUME/MUTE
button to adjust the volume level.
Please read the manual to fully understand
STi’s operation and features.
QuickMount Slot
Insert STi’s adjustable Windshield mount
into this slot. Page 7
QuickMount Button
Press the button, and slide the Windshield
mount into one of its four locking positions.
Page 7
Power
Press the PWR button to turn the STi on or
off.
AutoMute
STi’s patented AutoMute automatically
reduces the volume level of the audio alert
after a brief period. If you prefer, you can
turn AutoMute off. Page 8
Programming
The STi is ready to go, just plug it in and
turn it on. But you can also easily change 9
features for your preferences. Pages 12-16
4
Rear Laser Port
Receives laser signals from behind the
vehicle.
Power Jack
Plug the power cord into this connector.
Page 6
Earphone Jack
Accepts standard 3.5mm earphone.
VOLUME/MUTE Button
Press and hold the VOLUME/MUTE button
(below the display) to adjust the alert
volume level.
Briefly press this button to silence the
audio for a specific alert. (The audio will
alert you to the next encounter.) Page 8
Sensitivity Button (SENS)
Switches between Highway, AutoScan, City
and City NoX settings. In general, we
recommend the AutoScan mode. Page 8
5
STi Manual 3/28/05 3:39 PM Page 7