Beltronics STi DRIVER - Manual (Page 9)

Details of Programming
14
Pilot (Power-on indication)
Pilot HWY (Full description)
In this setting, the STi will display
“Highway,” “City,” or “AutoScan” as its
power-on indication. (factory default)
Pilot H (Letter)
In this setting, the STi will display “H” for
Highway, “A” for AutoScan,“C” for City, and
“Cnx” for City NoX.
Pilot V (Vehicle voltage)
In this setting, the STi will continually
display “H” for Highway, A” for
AutoScan,“C” for City, and “Cnx” for City
NoX, and the vehicle’s voltage.
Alamp
Alamp On (alert lamp on)
In this setting, the backlit VOLUME/MUTE
will flash on and off during an alert.
AlampOFF (alert lamp off)
In this setting, the VOLUME/MUTE backlit
button will not flash on and off during an
alert.
Voice
Voice On (Voice announcements on)
In this setting, all radar, laser, and SWS
messages (if programmed) will be
announced using a digital voice.
Voice Off (Voice announcements off)
In this setting, only the distinct audio tone
will be heard when a radar, Laser, or SWS
message is detected.
Power-on Sequence
PwrOnSTD (Standard)
In this setting, each time you turn on the
STi, it will display “Bel STi,” “LASER,”
“Ka-band,” “K-band,” “X-band,” followed by
a brief SWS alert. (factory default)
If any of the factory default bands have
been disabled, a double X-band tone and
corresponding message (i.e. “X OFF”), will
alert you that one or more bands have been
turned off.
15
PwrOnFST (Fast power-on)
In this setting, the STi will provide a single
X-band tone if the factory default settings
have not been changed. If any of the factory
default band settings have been disabled, a
double X-band tone and corresponding
message (i.e. “X OFF”), will alert you that
one or more bands have been turned off.
Signal Strength Meter
MeterSTD (Standard meter)
In this setting, the meter displays the band
of the received signal, and a bar graph
shows the relative signal strength. (factory
default)
MeterTHT (Threat Display)
In this setting, the meter will simultaneously
track multiple radar signals, including
relative signal strength for each.
MeterTEC (Tech Display meter)
In this setting, the meter displays the actual
numeric frequency of the radar signal
received.
AutoMute
aMute ON (AutoMute on)
In this setting, the STi’s audio alerts will
initially be at the volume you set, but after a
few seconds, the STi will automatically
reduce the volume level, to keep you
informed, but not annoyed. (factory default)
aMuteOFF (AutoMute off)
With AutoMute off, the STi’s audio alerts
will remain at the volume you set for the
duration of the radar encounter.
NOTE: When you are using the Dark
mode, the display will not display
anything. Only the power-on indication
on the SmartPlug will illuminate.
NOTE: A high or low voltage warning is
given any time the vehicle’s voltage
drops below 10.5 volts, or goes above
16.5 volts. This feature is always on,
regardless of the Pilot setting.
NOTE: The Tech Display feature is
explained in more detail on page 11.
STi Manual 3/28/05 3:39 PM Page 17