Bunn Autopod Brewer 411701 - Manual (Page 4)

Page 4
ADJUSTMENTS & PROGRAMMING
PROGRAMMING LOCKOUT SWITCH
PROGRAMMING THE BREWER
The programming of the brewer is divided into two levels. Brewing adjustments are in Level 1. Service func-
tions are accessed in Level 2.
The following function screens are in order of appearance. Each screen will have instructions on how to
access, and the procedures to program the various functions of the brewer.
IMPORTANT PROGRAMMING NOTES
- READ CAREFULLY -
To exit the programming mode at any time, press and hold "Hidden" switch located on the front panel. The
display will return to the MAIN SCREEN.
If none of the programming switches are pressed within one minute during programming, the display will
return to the MAIN SCREEN.
Always remember to place an empty cup under the sprayhead when operating the brewer during the set-up
of PULSE BREW, CALIBRATE FLOW and testing the brew valve in SERVICE TOOLS/TEST OUTPUTS.
(Mounted on main control board)
This switch can be set to prevent access to
the programming settings of the brewer.
Once all the correct brew settings are pro-
grammed, the operator can set the switch
to the "ON" position to prohibit anyone from
changing the settings. With the switch in the
"ON" position, the programming menus can
still be accessed to view the current settings.
However, no changes will be saved.
Disconnect brewer from power source
before removing any panel!
411701 061308