Breville IKON HEMISPHERE BBL550XL /B - Manual (Page 6)

11
Disassembling your blender for cleaning,
care and storage
Step 1.
Always make sure the Breville Hemisphere Blender is
off by pressing the ‘Power’ button on the control
panel. Then unplug the power cord.
Step 2.
Remove the blender pitcher from the motor base
by grabbing the handle and lifting the jug in an
upward direction.
Step 3.
Remove the blade assembly by upturning the blender
jug and twisting the Blade Removal System
clockwise, (see fig 1) then lift upwards and away
from the base of the blender. The circular plastic
surround attached to the base of the blender jug is
not removable.
Step 4.
Remove the silicon seal from the blade assembly
The Breville Hemisphere Blender features a one
piece Blade Removal System for the easy
removal of the blade and jug for cleaning.
Note
Operating your Breville Hemisphere Blender
continued
Step 11.
At the end of use, always make sure the Breville
Hemisphere Blender is turned off by pressing the ‘Power’
button on the control panel. And then unplug the cord.
Make sure the motor and blades have completely
stopped before attempting to move the appliance, or
when the Breville Hemisphere Blender is not in use
and before disassembling, cleaning and storing.
The Breville ikon Hemisphere Blender features a
motor overload protection feature. If the motor is
being overloaded, the motor will stop and the
function key LED's will illuminate and flash. To
restart it again, unplug from the mains and let it
cool down for 30 minutes or longer.
Note
• During the blending process, ingredients may
stick to the sides of the blender pitcher. To
push the food back onto the blades, press the
‘Power’ button on the control panel and
remove the power cord. Remove the lid and
use a plastic spatula to scrape down the sides
of the pitcher. Replace the lid before
recommencing blending.
• If any moisture or liquid appears on top of the
motor base during blending, press the ‘Power’
button on the control panel, switch off at the
power outlet and remove the power plug.
Remove the blender pitcher. Wipe the motor
base immediately with a dry cloth or paper
towel to absorb the liquid. Check that the
blender pitcher is correctly assembled.
Note
10
Fig 1