Philips ErgoFit Aspirador sin bolsa - Manual (Page 12)

Clean the washable HEPA 13 filter every 6 months. You can clean the washable HEPA 13 filter max.
4 times. Replace the filter after it has been cleaned 4 times.
Note: Do not clean the HEPA 13 filter in the washing machine, but follow the procedure below.
1 Unplug the appliance.
2 Grab the release tabs of the HEPA filter cover to open and remove the filter cover (Fig. 38).
3 Take out the washable HEPA 13 filter (Fig. 39).
4 Rinse the pleated side of the HEPA 13 filter under a warm slow-running tap (Fig. 40).
- Hold the filter in such a way that the pleated side points upwards and the water flows parallel
to the pleats. Hold the filter at an angle so that the water washes away the dirt inside the pleats.
- Turn the filter 180° and let the water flow along the pleats in the opposite direction (Fig. 41).
- Continue this process until the filter is clean.
Never clean the washable filter with a brush (Fig. 42).
Note: Cleaning does not restore the original colour of the filter, but does restore its filtration power.
5 Carefully shake the water from the surface of the filter.
6 Let the HEPA filter dry completely.
7 Place the dry HEPA filter back into the appliance.
8 Reattach the top of the filter cover (1) and then close the cover (2) (‘click’) (Fig. 43).
replacement
Batteries of remote control
1 Replace the batteries when the light on top of the remote control does not flash when you
press any button (Fig. 44).
Note: Your remote control may differ from the one shown in the figure.
2 Follow steps 1 to 3 in chapter ‘Before first use’.
storage
Note: Before you store the appliance, always make sure you have cleaned the filter cylinder by pressing
the AutoClean button (specific types only) or with the filter-cleaning handle (specific types only). See
section ‘Cleaning the filter cylinder’ in chapter ‘Using the appliance’.
1 Switch off the appliance and remove the mains plug from the wall socket (Fig. 20).
2 Press the cord rewind button to rewind the mains cord (Fig. 45).
3 Adjust the telescopic tube to the shortest length.
4 Put the Tri-Active nozzle in the carpet setting when you store it (brush strip retracted into
the nozzle). Also prevent the side brushes from becoming bent (Fig. 18).
5 Use the storage grip to put the appliance in upright position. Insert the ridge on the nozzle
into the storage slot on the appliance. (Fig. 46)
Tip: You can also detach the tube from the hose.
Tip: You can also store the appliance horizontally. In this case, insert the ridge on the nozzle into the
parking slot.
English 12