Philips ErgoFit Aspirador sin bolsa - Manual (Page 13)

ordering accessories and filters
To purchase accessories and filters, visit our website www.philps.com, contact the Philips Consumer
Care Centre in your country or visit your vacuum cleaner specialist.
If you have any difficulties obtaining filters or other accessories for this appliance, contact the Philips
Consumer Care Centre in your country or consult the worldwide guarantee leaflet.
- Washable Ultra Clean Air HEPA 13 filters are available under service number 432200493350
- Filter cylinder for FC9262, dark aubergine: 432200909850
- Filter cylinder for FC9256, ice white: 4322 009 09840
- Filter cylinder for FC9258, pea green: 432200900090
Environment
- The batteries of the remote control contain substances that may pollute the environment. Do
not throw away batteries with the normal household waste, but dispose of them at an official
collection point for batteries. Always remove the batteries of the remote control before you
discard and hand in the appliance at an official collection point (Fig. 47).
- Do not throw away the appliance with the normal household waste at the end of its life, but
hand it in at an official collection point for recycling. By doing this, you help to preserve the
environment (Fig. 48).
guarantee and service
If you need service or information or if you have a problem, please visit the Philips website at www.
philips.com or contact the Philips Consumer Care Centre in your country (you find its phone
number in the worldwide guarantee leaflet). If there is no Consumer Care Centre in your country,
go to your local Philips dealer.
troubleshooting
This chapter summarises the most common problems you could encounter with the appliance. If
you are unable to solve the problem with the information below, contact the Consumer Care
Centre in your country.
Problem Possible cause Solution
The light in the
AutoClean button
(specific types only)
or the filter-
cleaning reminder
light (specific types
only) flashes.
The filter cylinder
needs to be cleaned.
Press the AutoClean button (specific types
only) or turn the filter-cleaning handle (specific
types only) to clean the filter cylinder.
The suction power
is insufficient.
You have selected a
low suction power
setting.
Select a higher suction power setting.
The filter cylinder is
clogged with dirt.
Clean the filter cylinder (see chapter ‘Cleaning
and maintenance’).
The motor protection
filter and/or the HEPA
filter are dirty.
Clean or replace the filters (see chapter ‘Cleaning
and maintenance’).
English 13