Bissell Cleanview Helix 22C1 - Manual (Page 10)

10
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
M
aintenance and care
Cleaning the pre-motor filter
1. Unplug the cleaner from electrical outlet.
2. The pre-motor filter protects the motor from debris.
It is located underneath the filter cup in the center
of the round part of the Lock ‘n Seal lever.
3. Remove the small round filter and any debris
on top of it. Rinse well under warm water, then
air dry thoroughly before replacing.
Replacing the post-motor filter
Use only genuine bISSEll style 9 (#32076)
replacement filters in your bISSEll Cleanview
helix.
1. Unplug the cleaner from electrical outlet.
2. The post-motor filter assists in the filtration
process to return clean air to the room. It is
located behind the door on the side of the
vacuum. When the filter becomes dirty, open
the door, remove the filter and replace.
The white, pleated HEPA media filter is not
washable.
note: a basic washable post-motor
filter with reduced filtration is available if
desired.
Post-Motor
Filter
WaRnInG:
to reduce the risk of injury
from moving parts, turn
off vacuum cleaner and
disconnect power plug
from electrical outlet.
WaRnInG:
Do not operate cleaner
with damp or wet
filters or without all
filters in place.
Pre-Motor
Filter