Best IS23 - Manual (Page 10)

- 10 -
INSTALL RANGE HOOD
1. Raise the hood up into position under the
range hood. Control switches must be lo-
cated on the support frame side marked
“FRONT”.
2. Attach the hood using (4) washers and (4)
hex nuts.
INSTALL ELECTRICAL WIRING
NOTE: ELECTRICAL WIRING MUST BE DONE
BY A QUALIFIED PERSON(S) IN ACCORDANCE
WITH ALL APPLICABLE CODES AND STAN-
DARDS, INCLUDING FIRE-RATED CONSTRUC-
TION CODES AND STANDARDS. THIS RANGE
HOOD MUST BE PROPERLY GROUNDED.
TURN OFF POWER AT SERVICE ENTRANCE
BEFORE WIRING THIS HOOD.
1. Remove a knockout from the bottom of the
wiring box and one from the side.
2. Install the plastic bushing into the bottom
hole. Route the black, white, and green
ground wires from the hood into the wiring
box.
3. Secure the wiring box to the hood with (2)
3.9 x 9.5 mm screws and (2) serrated
washers.
4. Feed 6” of power cable into the wiring box.
Secure cable to the wiring box using an
appropriate connector.
5. Make electrical connections. Wire black to
black, white to white, and green to ground.
6. Push all wiring inside the wiring box. Make
sure wires are not pinched. Install cover and
secure with (2) 3.9 x 9.5 mm screws and (2)
serrated washers.
7. Remove the (2) temporary screws and move
the lower flue down into position on the
hood. Secure with (2) 3.9 x 13 mm screws.
WIRING BOX
WIRING
WIRING
BOX
BUSHING
BOLT
NUT
WASHERS
6.4 MM