Philips BEARDTRIMMER Series 7000 barbero con sistema de aspiración - Manual (Page 5)

- Children should be supervised to ensure that they do not play with the
appliance.
- Always check the appliance before you use it. Do not use the appliance
if it is damaged, as this may cause injury.
- Do not use the appliance in the bath or in the shower.
Caution
- Only use the adapter supplied.
- Use, charge and store the appliance at a temperature between
5°C and 35°C.
- Do not charge the appliance in the storage pouch supplied
(BT7085 only).
- Do not use the appliance if one of the trimming combs or the cutting
unit is damaged or broken, as this may cause injury.
- If the adapter, the cutting unit or one of the trimming combs is
damaged, always have it replaced with one of the original type in order
to avoid a hazard.
- This appliance is only intended for trimming the human beard. Do not
use it for any other purpose.
General
- The adapter is equipped with an automatic voltage selector and is
suitable for mains voltages ranging from 100 to 240 volts.
- The adapter transforms 220-240 volts to a safe low voltage of less
than 24 volts.
- Noise level: Lc = 65 dB(A).
Electromagnetic fields (EMF)
- This Philips appliance complies with all applicable standards and
regulations regarding exposure to electromagnetic fields.
Preparing for use
Charging (BT7085/QT4070)
Charge the appliance fully before you use it for the first time and after a
long period of disuse.
Standard charging takes approximately 60 minutes.
1 Switch off the appliance before you charge it.
2 Insert the appliance plug into the appliance and put the adapter in
the wall socket.
, When you start charging the empty appliance, the bottom segment
of the charge level indicator flashes orange. When the battery
contains enough power for one trimming session of approx.
7 minutes, the bottom segment starts flashing blue.
, First the bottom segment of the charge level indicator flashes blue,
then the second segment and so on, until the appliance is fully
charged.
, When the appliance is fully charged, all segments of the charge level
indicator light up blue continuously.
, If the fully charged appliance is still connected to the mains after
1 hour, the segments of the charge level indicator go out.
ENGLISH 5