Philips BEARDTRIMMER Series 7000 barbero con sistema de aspiración - Manual (Page 9)

Absorbing cut hairs
The vacuum system is activated automatically as soon as you switch on the
appliance. It absorbs cut hairs during every kind of use, i.e. trimming with
and without trimming comb and contouring.
We advise you to empty the hair-collection chamber after each trimming
session. When you trim long, dense beards, it may also be necessary to
empty the hair-collection chamber during the trimming session in order to
maintain optimal suction performance (see chapter ‘Cleaning’, section ‘Hair-
collection chamber’).
Note: To ensure optimal functioning of the vacuum system, do not cut off more
than approx. 7mm of your overall beard length at a time. If you want to cut
your beard shorter, repeat the process one or more times.
Travel lock (BT7085/QT4070 only)
You can lock the appliance when you are going to travel. The travel lock
prevents the appliance from being switched on by accident.
Activating the travel lock
1 Press and hold the on/off button for at least 6 seconds.
, The display counts down from 3 to 1. Then the travel lock indicator
appears on the display to indicate that the appliance is locked.
Deactivating the travel lock
1 Press and hold the on/off button for at least 6 seconds.
, The display counts down from 3 to 1. Then the travel lock indicator
disappears from the display to indicate that the appliance is unlocked.
Note: The travel lock is deactivated automatically when you connect the
appliance to the mains.
Cleaning
Never use scouring pads, abrasive cleaning agents or aggressive liquids
such as alcohol, petrol or acetone to clean the appliance.
Do not immerse the appliance in water or any other liquid, nor rinse it
under the tap.
ENGLISH 9