Philips Azur Fer vapeur - Manual (Page 11)

4 Let the iron cool down before you store it.
storage
1 Set the steam control to position 0 and unplug the iron.
2 Empty the water tank (Fig. 16).
3 Let the iron cool down in a safe place.
4 Wind the mains cord and fix it with the cord binder. (Fig. 17)
5 Store the iron on its heel on a stable surface.
Heat-resistant protective cover (specific types only)
You can store the iron on the heat-resistant protective cover immediately after ironing. It is not
necessary to let the iron cool down first.
Do not use the heat-resistant protective cover during ironing.
1 Put the iron on the heat-resistant protective cover (Fig. 18).
2 Insert the tip of the soleplate into the heat-resistant protective cover (1) and then press
down the heel of the iron (2).
Environment
- Do not throw away the appliance with the normal household waste at the end of its life, but
hand it in at an official collection point for recycling. By doing this, you help to preserve the
environment (Fig. 19).
Guarantee and service
If you need service or information or if you have a problem, please visit the Philips website at
www.philips.com/support or contact the Philips Consumer Care Centre in your country.
You find its phone number in the worldwide guarantee leaflet. If there is no Consumer Care
Centre in your country, go to your local Philips dealer.
troubleshooting
This chapter summarises the most common problems you could encounter with the appliance. If
you are unable to solve the problem with the information below, visit www.philips.com/support
for a list of frequently asked questions or contact the Consumer Care Centre in your country.
Problem Possible cause Solution
The iron is
plugged in, but the
soleplate is cold.
There is a connection
problem.
Check the mains cord, the plug and the wall
socket.
The temperature dial is set
to MIN.
Set the temperature dial to the required
position.
The iron does not
produce any steam.
There is not enough water
in the water tank.
Fill the water tank (see chapter ‘Preparing for
use’, section ‘Filling the water tank’).
The steam control is set to
position 0.
Set the steam control to a position between
1 and 6 (see chapter ‘Using the appliance’,
section ‘Steam ironing’).
EnGlish 11