Bradford-White Corp Commercial Energy Saver Gas Millivolt - Manual (Page 2)

Standard Equipment Features:
Non-CFC foam insulation.
Vitraglas ® lined tank— Bradford White water heater
tanks are protected from the corrosive effects of hot water by
an exclusive ceramic porcelain-like coating. The Bradford
White high silica Vitraglas
® lining provides a tough interior
surface for our water heater tanks, which must withstand the
wearing effects of high volume and high temperature hot
water.
Factory installed Hydrojet ® Sediment
Reduction System— cold inlet sediment reduction
device made of stainless steel for increased durability. Helps
prevent sediment build up in tank.
Factory installed dielectric fittings— all heaters
equipped with special water heater nipples for longer heater
life. No special dielectric fittings to buy.
Flue damper— automatic flue damper reduces stand-by
loss, saving money and fuel.
Continuous pilot ignition— continuous pilot ignition
eliminates the need for an external electric source which is
used on other commercial water heaters.
Magnesium anode rods—
employed to provide an
extra measure of corrosion prevention for longer life.
Hand hole cleanout— allows inspection of tank
interior and facilitates removal of water heater's principal
deterrent to long life—accumulated lime and sediment
deposits.
Millivolt controls— no external electric source is
required for water heater operation. Adjustable thermostat to
any temperature up to 180°F (82°C). A manual reset Energy
Cut-Off (E.C.O.) shuts off all gas in event of an overheat
condition.
Brass drain valve.
T&P relief valve installed.
Three year limited warranty—
protects your
investment in a quality glass lined water heater. If the tank
leaks for reasons of faulty materials, workmanship, or
corrosion within the warranty period, the water heater will be
replaced with a comparable water heater of our manufacture.
(Exclusive of all shipping and reinstallation costs.) Some states
do not allow limitations on warranties. See complete copy of
the warranty included with the water heater.
One year limited parts warranty— these quality
components are manufactured for us by industry leaders and
will be replaced in the event of failure during the parts
warranty period (exclusive of shipping and reinstallation
costs.)
Design certified by CSA International
(formerly AGA and CGA)
All models listed with California Energy
Commission.
Optional Features:
NSF construction available.
North Carolina Code Compliant.
ASME code available on all models above
200,000 BTUH (58.6KW)