Bradford-White Corp Commercial Energy Saver Gas Millivolt - Manual (Page 3)

Millivolt Models
Dimensions
H
B
E
C
D
F
COLD
HOT
T & P
G
A
CLEANOUT
A
H
B
E
D
F
HOT
T & P
G
Sample Specification
The water heater shall be a Bradford White model with a storage capacity of not less than ____________ gallons (____________ liters), a minimum
gas input of ____________ BTUH (KWH), and a minimum recovery of _______ GPH (LPH) at 100°F (56°C). temperature rise. It shall be design
certified by CSA International (formerly AGA and CGA) for 180°F (82°C). application, either with or without a separate storage tank. The tank shall
be lined with Vitraglas
® vitreous enamel and shall have a bolted hand hole cleanout. The tank shall have ____________ extruded magnesium anode
rods installed in separate head couplings and extended to within three inches of the bottom. The heater shall be insulated with non-CFC foam
insulation. This water heater shall be equipped with an ASME rated T&P relief valve, a continuous pilot ignition system and flue damper. The entire
installation shall be made in compliance with state and local codes and ordinances.
Dimensions and specifications subject to change without notice in accordance with our policy of continuous product improvement.
Top and Front
DM75T125
DM80T180, 199, 250
DM100T199, 250
Top Front, Rear
DM100L199, 250, 270
DM100S199, 250
Water Connections
Front and Rear
DM75T160
DM38T155
Water Connections