Bel Canto Design eVo6 - Manual (Page 7)

Warning!
Make certain that any
output terminal is not connected to a
chassis or earth ground.
Connect loudspeakers to the outputs
of the eVo amplifier using the 5-way
binding posts located on the rear of
the amplifier. The red or black center
plug in the output post can be
removed for use with banana type
connectors. Unscrew the binding
post until the center plug comes out.
Do not connect speaker terminals to
a chassis or earth ground connection.
The Anti-Phase operation of the out-
puts would result in one of the active
outputs being connected to ground
and cause the amplifier to go into
protection mode and shut itself off.
Also when connecting the amplifier
in balanced-mode mono operation
both terminals are driven actively
and can not be grounded.
page 7 © 2002-2004 bel canto design, Ltd. eVo User’s Guide 042104
Loudspeaker Connection and Power Output Options
Balanced Mono Mode Operation
High-power balanced mono operation
can be obtained with the simple push
of a button. Connect one input cable to
any of the 4 input jacks on an eVo2 or
input jack sets on an eVo4 or eVo6.
Then depress the MONO/STEREO
mode button. Connect the loudspeaker
to the output terminals indicated for
mono-mode operation on the back
panel.