Bel Canto Design eVo6 - Manual (Page 8)

The front panel switch or rear panel
12 volt trigger input is used to power
on the amplifier. When using the 12
volt trigger the front panel switch
should remain in the off (out) posi-
tion. The eVo amplifiers have been
designed to remain powered up at all
times, their very low standby power
is conducive to this. The blue front
panel LED remains on when the eVo
is in normal operating mode. When
the amplifier shuts down in protec- tion mode a small red LED lights next
to the front panel power switch. If
this occurs, remove power and
insure that no output terminal is con-
nected to ground or to another termi-
nal. Restore power and the amplifier
should return to normal operation.
If not then there may be an internal
fault and the amplifier should be
returned to an authorized service
center. Contact your dealer, distribu-
tor or Bel Canto Design.
Power On and Operation
page 8 © 2002-2004 bel canto design, Ltd. eVo User’s Guide 042104
eVo2
eVo4
eVo6