Philips SmallStar Aspirateur avec sac - Manual (Page 9)

7 Put the clean filter back into the filter holder.
8 Fit the two lugs at the bottom of the filter holder into the brackets (1). Then press the filter
holder home (‘click’) (2). (Fig. 19)
9 Place the bottom edge of the dustbag in front of the ridge on the bottom of the appliance
(1). Pull the cardboard front of the dustbag towards you (‘click’) (2). (Fig. 20)
Note: If no dustbag has been inserted, you cannot close the cover.
10 Close the cover.
replacement
Dustbag
Tip: We advise you to clean the motor protection filter every time you replace the dustbag (see chapter
‘Cleaning’).
Always unplug the appliance before you replace the dustbag.
Before replacing the dustbag
In some cases, the dustbag-full indicator can indicate that the dustbag is full, even though it is not.
This may occur if the pores of the dustbag are clogged (e.g. when you have vacuumed ashes, fine
sand, lime, cement dust and similar substances) or if something is blocking the nozzle, tube and/or
hose. If the pores of the dustbag are clogged, you have to replace the dustbag, even if it is not full
yet. If the dustbag is not clogged but not full either, something is blocking the nozzle, tube and/or
hose. In this case, do not replace the dustbag but remove the obstruction.
replacing the dustbag
- Replace the dustbag as soon as the dustbag-full indicator has changed colour permanently, i.e.
even when the nozzle is not placed on the floor (Fig. 21).
1 Pull at the cover release tab (1) and open the cover (2) (Fig. 15).
2 Pull the clamps aside (1) and pull the dustbag forward (2) (Fig. 16).
3 Pull the cardboard tag upwards to lift the dustbag out of the appliance. (Fig. 17)
, The dustbag is sealed automatically.
4 Place the bottom edge of the new dustbag in front of the ridge on the bottom of the
appliance (1). Pull the cardboard front of the dustbag towards you (‘click’) (2) (Fig. 22).
Note: If no dustbag has been inserted, you cannot close the cover.
5 Close the cover.
Clean air hEpa outlet filter
Your vacuum cleaner is equipped with a Clean Air HEPA outlet filter (service code 4222 459
48841).
Replace the Clean Air HEPA outlet filter every 12 months.
1 Switch off and unplug the appliance.
2 Pull at the grip on the filter grille (1) and remove it from the appliance (2) (Fig. 23).
3 Remove the Clean Air HEPA outlet filter from the appliance (Fig. 24).
4 Insert a new Clean Air HEPA outlet filter into the appliance (Fig. 25).
5 Reattach the filter grille to the appliance (‘click’) (Fig. 26).
English 9