BT PARAGON450 - Manual (Page 33)

BT Paragon 450 – Edition 05 – 02.11.04 – 5995
Remote access
You can operate your answering machine from any modern phone by
calling your BT Paragon 450 and entering a 4-digit security code. Please
refer to your Remote access card and keep this in a safe place.
The pre-set code is 0000. You can change this for added security.
Change remote access security code
1. Press then scroll to ANSWER SETTINGS and press .
2. Scroll or to display SECURITY CODE . Press . The current
code is displayed (original setting 0000 ).
3. Enter the new 4-digit code and press to confirm.
Using your answering machine via remote access
If you forget to switch on your answering machine, you can do it from
another phone.
1. Dial your phone number and let it ring. After 20 rings, your answering
machine will switch on.
2. When you hear your outgoing message, press . You will hear “Please
enter your security code”.
3. Enter your 4-digit code. If you have new messages, your machine
announces “You have (n) new messages”, and they are played. Or you will
hear “You have no new messages, to hear main menu, press 1”.
4. If you don’t give any instructions for approximately 8 seconds, your
BT Paragon 450 will hang up.
OK
OK ᮣ ᮤ
OK Menu
You can keep a note of your 4-digit remote
access code by writing it in the space
provided on page 40.
If you enter your security code incorrectly,
after the third attempt, your BT Paragon
450 will announce: “Incorrect security code,
thank you for calling” and will hang up.
33
5995 BT Paragon 450 UG [5] 2/11/04 4:36 pm Page 33