Bosch B24IF - Manual (Page 24)

24
Fault Remedial action Possible cause
Condensation forms on the
dispenser unit.
The ice maker is switched off
(see Switching off the ice maker").
The condensation heater does not
function.
You have to activate the condensation heater.
- Switch on the ice maker.
- Simultaneously hold down the LOCK OUT and the
AGITATION buttons for 3 seconds.
The WATER light and the ICE CUBE light flash twice.
The ice maker is switch off and the condensation heater
works.
To reĆactivate the condensation heater:
- Simultaneously hold down the LOCK OUT and the
AGITATION buttons for 3 seconds.
The WATER light and the ICE CUBE light flash once.
Ice cubes have an unpleasant
odor/flavor.
Ice which is stored for a long time may
absorb odors which impair their taste.
Dispose of old ice cubes. Use the ice maker more
frequently.
The ice cube container is dirty. Empty and wash out the ice cube container.
Unsealed packages in the freezer
transfer odor/flavor particles to the ice
cubes.
Check whether the frozen food has been packed
in airtight containers.
Clean the inside of the appliance. See section on Odors".
Ice maker is not producing any ice. The ice cube container is in the false
position.
Reinsert the container and slide it backwards to the end
position (see section Variable interior design").
The water pressure is too low. Check water pressure. The water pressure must be
between 25 and 120 p.s.i. (1.72ć8.25 bar).
The freezer compartment temperature
is too high.
Check temperature of the freezer compartment.
If required, lower the temperature.
A wrong water valve has been
installed.
SelfĆtapping valves and 3/16 inch (4.76 mm) saddle
valves reduce the water pressure and may eventually
block the pipe.
The manufacturer is not liable for damage to
property due to an incorrect installation or water
connection.
The agitation function in the ice cube
container is switch off. The filling level
sensor is blocked.
PullĆout and empty the ice cube container. Remove the
ice on the sensor.
Ice is not dispensed. Two ice cubes can by chance be
attached to each other. These ice
cubes, when joined together, can block
the ice chute so that no further ice can
be dispensed.
Open the door.
Remove all of the ice out of the ice chute.
The dispenser light does not
function.
The bulb is defective. Change the bulb (see Changing the bulb").
The ice maker is not producing
enough ice or the ice cubes are
The water pressure is too low. Check water pressure. The water pressure must be
between 25 and 120 p.s.i. (1.72ć8.25 bar). g
misshapen.
The freezer compartment temperature
is too low.
Check temperature of the freezer compartment.
If required increase the temperature.
Change the water filter. Instructions for changing the water filter can be found
in the section Water filter".