Boca Research FSP 44 - Manual (Page 15)

5.0 Standard Configuration
The FSP is factory configured for specific customer requirements using an enhanced
FGL package. Printing resolution is 300 dots per inch. For complete informa on
the FGL Programming Language, please see the programming guide. FGL printers
allow the user to adjust various printer options through the control panel.
To access and use the FACTORY MENU, follow these steps:
1. Flight strip stock should be loaded into the printer. The LCD window displays
the firmware level installed in the printer.
2. Press both MENU and CHOICES switches simultaneously for about three seconds.
The LCD window displays FACTORY MENU! .
3. To scroll through the menu topic, use MENU stopping on the topic you wish to
change.
4. Press CHOICES to scroll through choices in the selected topic. NOTE: The
printer displays a blinking cursor for the values presently stored in the printer.
5. Once you have found the new value you want, press TEST. The LCD window
displays EXIT AND SAVE?. If you wish to save the new value, press TEST
again.
6. If you do not wish to save the new value, press MENU. The LCD window
displays JUST EXIT?. Press TEST to exit the FACTORY MENU without
saving new values or press MENU to enter back into the FACTORY MENU.
9
TEST
CHOICES
MENU
CHECK
PAPER
PAPER
JAM DATA READY
Enters new value / Also
saves new values.
Selects proper menu topic
(baud rate, cut count, etc.)
Scrolls through choices in
individual menu topics.
tion