Boca Research FSP 44 - Manual (Page 29)

8.2 Cutter Assembly
8.4 General Cleaning
The interior of the printer should be cleaned whenever there is a visible accumulation
of dust. Use a small vacuum for cleaning. Be careful not to jar any of the printer’s
parts loose.
25
The SC cutter (SC2) system is a fully integrated rotary cutter mechanism powered by
a DC motor. The SC2 requires no adjustments and is rated for approximately 750,000
cuts.
Wait five seconds before feeding ticket stock into the printer after power up. During this
time the cutter will cycle once. If ticket stock is fed into the printer before five seconds,
a ticket jam could occur.
The cutter should be blown out with air periodically to prevent debris from building up
inside the cutter area. The required cleaning interval varies greatly depending on the
quality of the ticket stock and the amount of paper dust entering the cutter area.
8.3 Logic Board
The printed circuit boards used in this product have been manufactured using surface
mount technology. These printed circuit boards cannot be effectively repaired in the
field and should be returned to the manufacturer if repair is required.
Your printer has one large printed circuit board which houses all control and power
supply circuitry. ALL SERVICE SHOULD BE DONE WITH POWER OFF AND THE
AC CORD UNPLUGGED FROM THE PRINTER.
8.2a SC Cutter Assembly (SC2)
NOTE:
THE CUTTER ASSEMBLY MAY VARY DEPENDING ON THE DATE OF
MANUFACTURE OF THE PRINTER
The BOCA cutter (BC2) system is a fully integrated recipricating cutter mechanism
powered by a stepper motor. The BC2 requires no adjustments and is rated for
approximately 750,000 cuts.
When first powering up the printer, be aware of the following:
8.2b Boca Cutter Assembly (BC2)