Philips Performer Aspirateur avec sac - Manual (Page 9)

Note: This vacuum cleaner has been fitted with holes at the end of the handgrip. These holes may
prevent objects from getting stuck or damaged when you use your vacuum cleaner without the tube or
accessories supplied.
Attaching the normal handgrip (specific types only)
1 To connect the tube to the handgrip, press the spring-loaded lock button on the handgrip
and insert the handgrip into the tube. Fit the spring-loaded lock button into the opening in
the tube (‘click’) (Fig. 11).
2 Adjust the tube to the length you find most comfortable during vacuuming. Press one of the
two collars downwards and pull the tube part above the collar upwards or push it
downwards (Fig. 12).
3 To disconnect the tube from the handgrip, press the spring-loaded lock button and pull the
handgrip out of the tube.
Keep the tube away from your face when you extend it. The tube is very long.
hose
1 To connect the hose, push it firmly into the appliance (‘click’) (Fig. 13).
2 To disconnect the hose, push the buttons (1) and pull the hose out of the appliance
(2) (Fig. 14).
telescopic tube
1 Adjust the length of the tube in such a way that the flexible hose connection is at hip
level. (Fig. 15)
2 Hold the tube so that the standard handgrip is at hip level. (Fig. 8)
3 To connect the tube to a nozzle, press the spring-loaded lock button on the tube and insert
the tube into the nozzle. Fit the spring-loaded lock button into the opening in the nozzle
(‘click’) (Fig. 16).
- To disconnect the nozzle from the tube, press the spring-loaded lock button and pull the
accessory out of the tube.
Accessory holder (specific types only)
1 Slide the accessory holder with accessories onto the handgrip (‘click’) (Fig. 17).
2 To detach the accessory holder, squeeze the release levers together (1) and slide the
accessory holder off the handgrip (2) (Fig. 18).
Crevice tool and small nozzle (specific types only)
1 Connect the crevice tool (1) or small nozzle (2) with or without brush attachment (3) to the
tube or directly to the handgrip (Fig. 19).
Brush attachment (specific types only)
1 To assemble the brush attachment, slide it onto the bottom of the small nozzle
(‘click’) (Fig. 20).
2 To disassemble the brush attachment, slide it off the bottom of the small nozzle (Fig. 21).
Accessory holder (specific types only)
1 Snap the accessory holder onto the handgrip (Fig. 22).
2 Snap two accessories into the accessory holder:
- Crevice tool and small nozzle (Fig. 23).
English 9