Bard Economizer with exhaust WGEIFM-3C - Manual (Page 5)

Manual 2100-498C
Page
5 of 17
FIGURE 2
INSTALLATION OF ECONOMIZER
FIGURE 2 INSET
SIDE SECTION
5. Install ventilator sheet metal assembly by inserting
the ventilator into the unit – centering between the
tubing on the left and the control panel on the right.
Once the ventilator is fully inserted, slide the
ventilator to align screw hole through the front of
the condenser grille. (See Figure 2.)
IMPORTANT: Position front lip of ventilator on top of
front grille and condenser partition. (See Figure 2
inset.) This is important to ensure proper drainage
of any water entering damper assembly.
6. Open control panel to gain access to unit low
voltage terminal block.
7. Install loose piece wire harness plug into filter tray
& route wires into low volt box. (See Figure 3.)
(Save back two {2} long red wires with push-on
terminals.)
8. Plug wire plug from vent package installed in Steps
#1 through #6 into plug installed in Step #7.